discount sale prices on ??
 bimini tops for saleassembly of bimini topsboat tops & protection3 bow or 4 bow bimini coversfabrics for bimini and boat topsmeasuring for the top for your cuddy cabinbimini top installationprices for bimini topsaccessories and parts for boat topsboat top warrantyordering the topgood quality custom boat coversshipping the biminitrailering covers for boats & private water craft
This is where you'll need the Cool-Kit !
Step 1.
Step 2.
Locate the label on the underside of the fabric. This is the back of the top. 
Slide the large bow through the sleeve on the back of the top being sure 
that the 2 pre-drilled holes near the curve of the upright portion of the bow 
are facing toward the front of the top. Slide the meduim bow through the 
sleeve in the forward section of the bimini top being sure that the 2 pre-drilled 
holes near the curve of the upright portion of the bow are facing toward the
back of the top. Insert the last bow (there will be 2 for the 4 bow tops)
in the sleeve(s) provided.
Step 3.
Attach 2 straps to the Large bow (back) and 2 straps to the Medium bow 
(front) by passing the end of the bows through the loops in the straps and
securing each strap with 1 screw and 1 decorative washer per strap. These
screws go into the pre-drilled holes on the upright portions of the bows.
Step 4.
Step 5.
Step 6.
Pick up the assembled bimini top and hold in place at desired mounting
location on your boat. Extend the top to its fully open position and place
a pencil mark on your boat at the location where the largest bow will be
anchored to the boat. Place a corresponding pencil mark on the other
side of the boat. These are where your mounting brackets will be placed. 
Be sure that the 2 mounting points are the same disance from either the 
bow or the stern.
Step 7.
Place a mounting bracket at the appropriate location and outline it with
a pencil. Also mark the boat through the screw holes in the bracket.
Step 8.
Using a drill with a bit Smaller than the actual screws provided, drill the 
2 holes needed to secure the bracket to your boat.
Step 9.
Place the bracket in place and secure firmly to your boat. Repeat the
process for the other side of the boat.
Step 10.

Attach the main bow to the brackets on your boat.
Step 11.
Position the forward attaching eyes to the boat and drill the
holes needed to secure them to the boat. The forward strap
eyes should mounted at a position that places the straps at a
minimum 45 degree angle as they will take most of strain when
you are "under way".    Set the back eyes for the rear straps.
Adjust the straps so your top is riding near a horizontal position
and you are done !
An average Bimini top can be easily installed in a couple of hours.
Should you need any help before installing or during the process, 
call the toll free # below and we'll be glad to help !