800-982-6966 Fax 530-589-2510
Measuring for an Oval Dome
| The Dome Cover will need to overlap
the extreme outside edge of the pool.
It will then hang down about 6" to 8" and be secured to the uprights of the pool via a tensioned "bungee" style cord. (It fits much like a "tight" shower cap) Please provide the measurements in feet & inches to the nearest 1/4". ALL measurements need to be taken at the outside edge of the pool as indicated by the red lines shown in the pictures below. We will make your New Dome to these dimensions so please take your time and be accurate. |
| On a separate sheet of paper, make a bird's
eye view diagram of your pool.
The drawing need not be perfect or to scale. We only need it to verify the dimensions you provide. Here's an example of a drawing. There are many variations of ovals, so the example probably will not work for your pool. |
 |
 |
| Measure the entire perimeter of
the Top Cap of the pool. Perimeter = _____ft. _____in. |
Measure Every Top Cap Section
of the Top Rail. Insert dimensions below on the drawing you send. |
Please count each upright
around entire pool. # uprights =_____
Brand of Pool if known:
______________________________
Pool Manufacturers stated
Pool Size = _____x_____ foot Oval
(your
perimeter measurement will probably be much larger, as normally a pool
size is stated
as
a Wall to Wall dimension and yours will be an Outside Top Rail to Top
Rail dimension.)
| Name: _______________________________
(W) Phone # (_____) _____-_______ (H) Phone # (_____) _____-_______ Fax # (_____) _____-_______ |
| Notes: ________________________________________________
_____________________________________________________ _____________________________________________________ _____________________________________________________ |
